195N0030 by Danfoss

The Danfoss 195N0030 is an AC variable frequency drive in the VLT 2800 Low Voltage Drives series. Designed for panel installation, it controls the speed of small induction motors used on conveyors, mixers, pumps, and similar process equipment. By adjusting output frequency, the unit helps regulate motor speed, reduce energy use, and lessen mechanical wear during routine operation. It is suited to applications that need steady motor control in a compact cabinet-mounted format. In small automation systems, that kind of control helps process steps stay consistent when load conditions change during normal production.

It provides 0.75 kW of continuous power, which corresponds to 1.0 HP. The input range of 200-240 V AC matches common low-voltage three-phase mains used in light industrial equipment. A rating of IP20 protects against accidental contact with live parts, so the drive should be installed in a clean enclosure rather than in open exposure. The Bookstyle housing supports dense side-by-side mounting, which helps conserve panel space in compact cabinets. A built-in display (SLCP) on the front panel shows operating information and allows direct parameter adjustment. Heat is removed through the rear heat sink, which supports full-load operation without separate fan kits. Front access to the keypad and display also simplifies everyday status checks when the unit is mounted inside a control cabinet.

The drive is a standard unit with brake, so its internal brake chopper can absorb regenerated energy during rapid deceleration. It is supplied without coating, which means the circuit boards are exposed to ambient air and should be kept away from moisture or corrosive fumes. It is also delivered without an EMC filter, so external suppression may be needed where emission control is required. No application option card is installed, and the base configuration is intended for general process duties. Where line-noise limits apply, the required external filtering can be selected separately to match the installation. This setup is appropriate for straightforward motor-control applications where the required functions are handled by the drive's standard features.