134G7013 by Danfoss

The 134G7013 is a low-voltage AC drive produced by Danfoss for the VLT 2800 Low Voltage Drives series. It is designed to regulate induction motor speed in continuous-process applications such as pumping, conveying, and mixing duty. This gives users a compact controller that can be panel-mounted close to the load, which helps keep installation layouts neat in space-limited cabinets. The drive is intended for fixed electrical installation where nearby mounting can simplify cable routing to the motor and control terminals.

The unit delivers a power output of 2.2 kW, so it can run medium-sized pumps, conveyors, or mixers without external step-down hardware. Its input circuit accepts 380-480 V ±10% at 50/60 Hz, allowing direct connection to common industrial mains. A three-phase topology is used on both the supply and motor sides, which reduces current ripple and improves torque balance under variable loads. Environmental protection is rated at IP20, so the drive must be installed inside a clean electrical cabinet when airborne dust or moisture is present. The slim Book-style enclosure profile minimizes panel depth and permits dense side-by-side installation with other automation components. An integrated RFI filter is included, and no additional application option board or fieldbus option is present, so remote control relies on hard-wired I/O. A protective conformal coating is applied to the internal boards to guard against conductive condensation.

Motor data and alarm codes are shown on the built-in display (SLCP), so parameter checks can be performed without a handheld programmer. This local interface also makes routine status review straightforward when the unit is mounted inside a control cabinet. During line disturbances, the integrated brake chopper works with the standard brake hardware to dissipate regenerated energy. This helps handle braking energy during deceleration instead of allowing the DC bus voltage to rise unchecked. The output is also rated at 3.0 HP, providing an imperial power reference alongside the metric value. For conducted emissions, the factory-mounted filter meets EN 55011 Class A1, enabling installation on commercial power networks without external suppression.