02-104807 by Vickers

The 02-104807 connector body is produced by Vickers as part of the Vickers Accessories series. It is an edge-mount interface that allows Eurocard control modules to be wired to field devices without soldering. In an automation cabinet, the part sits between a DIN 41612 card edge and discrete screw terminals, letting I/O boards be replaced quickly while keeping panel wiring fixed. By combining mechanical support and signal routing, the component simplifies system upgrades and helps reduce interruption on production lines. This arrangement also keeps field wiring organized at the cabinet face and leaves the card connection accessible during service.

The connector body length is 169 mm measured along the F32 reference, giving room for cable bends while staying inside a standard sub-rack. A F32 Female insert follows the DIN 41612 geometry, so Eurocards using that pattern can slide in without lateral stress. Four clearance holes of 4.2 mm diameter accept M4 hardware, and a rectangular bolt grid of 127 mm x 40 mm keeps the block stable under vibration. The design routes supply, control, and ground lines directly from the mating contacts to individual screw lugs, reducing installation time compared with crimped harnesses.

Across the carrier rail, the total span, including the mated Eurocard, reaches 221 mm, ensuring that plugged boards remain flush with adjacent modules. Electrical paths are restricted to rows b and z only, which prevents accidental cross-connection with row a circuits reserved for backplane power. Field conductors land on screw terminals, so signals can be rerouted with a flat screwdriver and no special tools. The consistent layout supports use in older electro-hydraulic systems that already use the same accessory code.