VAC2-D8-A by Okuma
Get a Quote for VAC2-D8-A
Request a quote or call us now at 1-888-551-3082!
We respect your privacy. Your information is safe and will never be shared.
Secure Online
Checkout
Free Ground
Shipping
One Year
Warranty
The VAC2-D8-A spindle drive is produced by Okuma and supplied under the VAC Spindle Drives series. It functions as the inverter section in an Okuma machining center, routing controlled three-phase power to the high-speed spindle so cutting loads remain stable throughout rapid cycles. The module communicates with OSP 5020 and OSP 7000 numerical controls, passing speed commands and status bits through standardized terminals. By integrating current regulation, fault detection, and thermal monitoring in one enclosure, the drive simplifies cabinet wiring while ensuring precise acceleration, deceleration, and constant-speed holding during metal-removal operations.
A base circuit fuse rated at 200 V, 5 A and designated as type F7161 protects the primary DC link against short circuits, while a bank of six line fuses isolates individual phase legs during overcurrent events. Switching energy is processed by six transistor modules that generate the variable-frequency output, while back EMF is returned through one diode module for regenerative braking. Input safety is reinforced by an integrated no-fuse breaker, eliminating the need for replaceable mains fuses and allowing a quick reset after minor trips. An optical interface handles command and feedback data, reducing noise coupling between the drive and the CNC control rack. These components coordinate with the supported OSP controls so spindle speed references and alarms travel over a deterministic optical link.
Power for the logic and gate drives is drawn from the dedicated D8A power supply unit seated on the chassis. Real-time firing patterns are generated on the VAC Card 1 control card, while closed-loop speed processing resides on the companion VAC Board II PCB. Heat produced by the transistor stack exits through a rear heat sink fan, permitting high duty cycles without external ducting. This arrangement leaves the optical communication path unobstructed and keeps cabinet temperatures within component tolerances during continuous, high-speed machining.
Technical Specifications
Base Circuit Fuse
200 V, 5 A, F7161
Control Card
VAC Card 1
Control Pcb
VAC Board II
Cooling Method
Rear Heat-Sink Fan
Diode Modules
1
Fuse Count
6
Input Protection
No-Fuse Breaker
Interface Type
Optical
Power Supply Unit
D8A
Supported Controls
OSP 5020, OSP 7000
Transistor Modules
6
Contact Us
1620 Old Apex Road, Cary, NC 27513, USA
Toll Free: 1-888-551-3082
International: 1-919-443-0207
Fax: 1-919-867-6204
Email: sales@wakeindustrial.com
Need Assistance?
Our team is here to help you find the right part for your needs.







