MIV08-3-V5 by Okuma
Get a Quote for MIV08-3-V5
Request a quote or call us now at 1-888-551-3082!
We respect your privacy. Your information is safe and will never be shared.
Secure Online
Checkout
Free Ground
Shipping
One Year
Warranty
The MIV08-3-V5 is an inverter unit produced by Okuma within the MIV Servo Drives series. As a servo drive component, it converts power from a rectified DC bus into a pulse-width-modulated output that regulates motor speed and torque. The unit supports VAC and interior permanent-magnet servo motors used in machine-tool axes and automated handling systems. Its closed-loop control architecture allows the connected motor to follow commands from the CNC controller while responding to changing loads and motion profiles.
The internal control board is the ICB3 type, which contains the motion processor and communication interfaces used to coordinate operation with the CNC controller. Logic circuits and gate drivers are energized by a separate 24 VDC supply, isolating the low-level electronics from transients generated by the power stage. The main power section receives energy from a 300 VDC bus. This constant link voltage allows the inverter to synthesize controlled phase currents for the connected servo motor. Under continuous duty, the module can deliver 7.5 kW of electrical output, corresponding to a mechanical shaft output of approximately 10 hp. The control electronics regulate current in response to feedback, helping the motor maintain the commanded speed or torque during acceleration, steady operation, and deceleration.
The housing measures 100 mm in width, providing a narrow profile for installation beside other power and control modules. It stands 380 mm high, so the cabinet must provide sufficient vertical clearance for the enclosure and its electrical connections. The unit has a depth of 325 mm, which must be considered when selecting the cabinet and arranging the mounting panel. Its rectangular enclosure allows the inverter to fit into control cabinets used with compatible Okuma machine systems. A mass of 7.3 kg provides sufficient structural and thermal capacity for the internal power electronics without placing excessive load on the mounting surface. The inverter is intended to connect directly to the compatible motor and control components used in Okuma machining equipment.
Technical Specifications
Control Board Type
ICB3
Control Power
24 VDC
Control Rom Type
5
Dc Bus Supply
300 VDC
Depth
325 mm
Firmware Target
ICB-H
Height
380 mm
Horsepower
10 hp
Product type
Okuma Inverter Unit
Rated Continuous Capacity
7.5 kW
Supported Motor
VAC Motor / IPM Motor
Unit Generation
First Generation
Weight
7.3 kg
Width
100 mm
Contact Us
1620 Old Apex Road, Cary, NC 27513, USA
Toll Free: 1-888-551-3082
International: 1-919-443-0207
Fax: 1-919-867-6204
Email: sales@wakeindustrial.com
Need Assistance?
Our team is here to help you find the right part for your needs.







