BDU-30A by Okuma
Get a Quote for BDU-30A
Request a quote or call us now at 1-888-551-3082!
We respect your privacy. Your information is safe and will never be shared.
Secure Online
Checkout
Free Ground
Shipping
One Year
Warranty
The BDU-30A is a servo amplifier module produced by Okuma for the BDU Servomotor Drives series. Serving as the intermediary between the OSP motion controller and a brushless servomotor, it conditions line power and processes closed-loop feedback so commanded torque, speed, and position are maintained under varying mechanical loads. In a typical machining center, the drive accepts digital motion data from the host control, monitors encoder signals, and modulates its transistor bridge to keep the connected axis synchronized with programmed tool paths. This arrangement supports precise axis movement during cutting, positioning, and rapid-traverse operations.
The power stage uses transistor-based PWM switching, allowing fine duty-cycle control of the motor voltage. On the supply side, the amplifier is rated for 200-220 VAC mains at 50/60 Hz, which are rectified to a 300 VDC internal bus. The input and motor output use three-phase power for balanced current distribution. The amplifier can provide up to 21 A of continuous output current, which is monitored and limited by onboard current shunts. Motion references arrive through the Digital RCON command channel, while rotor position data return through the high-resolution OSP encoder interface. Each amplifier operates one motor, preventing the control parameters for separate axes from affecting one another.
The BDU-30A chassis is supplied in the Base Unit, BDC, SVC configuration, providing access to the diagnostic panel and power section in one enclosure. Protection circuitry disconnects the bridge if the DC bus rises to 430 VDC or falls below 220 VDC, reducing component stress during line surges or brownouts. One DC power supply can support as many as 6 axes, and the amplifier reports its share of that resource through a seven-lamp DCPS status array. Servo condition codes appear on a front panel with 10 LEDs, making operating states and alarms easy to identify. The visible indicators provide status information without requiring access to the enclosed power electronics.
Technical Specifications
Amplifier Build
Base Unit, BDC, SVC
Command Signal
Digital RCON
Dc Bus Voltage
300 VDC
Dcps Led Count
7
Drive Technology
Transistor PWM
Feedback Encoder
High-Res OSP Encoder
High-voltage Trip
430 VDC
Input Frequency
50/60 Hz
Input Phases
3-Phase
Input Voltage
200-220 VAC
Low-voltage Trip
220 VDC
Max Axes Per Dcps
6
Motors Per Amplifier
1
Output Current
21 A
Output Phases
3-Phase
Svc Led Count
10
Contact Us
1620 Old Apex Road, Cary, NC 27513, USA
Toll Free: 1-888-551-3082
International: 1-919-443-0207
Fax: 1-919-867-6204
Email: sales@wakeindustrial.com
Need Assistance?
Our team is here to help you find the right part for your needs.







