PXSWLPRCYL2062PRNO3WDCEURO by Danaher

The PXSWLPRCYL2062PRNO3WDCEURO is a proximity sensor produced by Danaher within the Timers and Controllers series. It is designed to detect metallic targets in automated machinery. The sensor returns a discrete PNP signal to the controller, allowing position confirmation, part presence checking, or stroke-end verification in pneumatic and hydraulic actuators.

The device operates at supply voltages up to 30 VDC and can switch loads as high as 200 mA. When the output is open, leakage current is limited to 10 µA, reducing the risk of false triggering at sensitive PLC inputs. The voltage drop across the output transistor is limited to 2.0 V at 100 mA, so most of the supply voltage remains available to the load. The sensor supports switching frequencies up to 16 Hz, which is adequate for typical cylinder cycles. Its three-wire architecture matches common sensor power distribution schemes. The PNP output has a normally open function, meaning the load is connected to the positive rail and energized only when a target is detected. Reverse-polarity protection prevents damage from incorrect wiring, while latching short-circuit protection shuts down the device until power is cycled to protect it against sustained faults.

A sealed cylindrical body withstands hydraulic pressures up to 3000 psi, and the stainless steel probe measures 2.062 inches in length to reach into manifold cavities. The sensing face reliably detects targets at a nominal distance of 0.080 inches. Electrical connection is made through a 4-pin Euro connector, allowing the sensor to be disconnected without rewiring the fixed three-conductor harness. Continuous operation is permitted at ambient temperatures up to 158 °F, enabling installation on heated tooling or near fluid-power manifolds.