8LSA24.R0060D200-0 by B & R Automation

The 8LSA24.R0060D200-0 is a three-phase synchronous motor manufactured by B&R Automation for the 8LS Synchronous Motors series. Identified by the 8LSA designation, it follows the standard configuration, has no reinforced bearing, and is supplied in length code 4. Through resolver feedback, it pairs with servo amplifiers to drive packaging frames, pick-and-place axes, and similar motion tasks that demand closed-loop control. Its synchronous design supports accurate speed regulation and repeatable positioning during frequent start-stop cycles.

This model is rated for a top speed of 6000 rpm, so the shaft can track high-cycle command profiles without mechanical overspeed. A flange dimension of 58 mm keeps the mounting interface consistent across the series. Point-to-point repeatability is supported by a positioning precision of 10 arcmin, making the motor suitable for indexing tables and feeder screws. Heat is removed by self-cooling through free circulation, eliminating the need for external blowers and allowing installation in compact enclosures. Rotor position is measured by a resolver, which supplies analog sine-cosine signals that remain resistant to electrical noise and continue to operate reliably at elevated ambient temperatures.

Cabling exits through an angled swivel connection, so the connector shell can clear adjacent components when space behind the motor is limited. A standard holding brake locks the rotor when power is removed, helping prevent drift on vertical axes. The shaft terminates in a smooth shaft end that accepts friction-fit couplings without keyways. An integrated mounting flange allows direct attachment to gearboxes or adapter plates, and the motor should be installed where lubricant splash is not present because it does not use an oil seal. The connection hardware is a sealed industrial connector, and the resolver leads share that plug to simplify wiring and reduce cable routing complexity.