EK1100-0008 by Beckhoff
Get a Quote for EK1100-0008
Request a quote or call us now at 1-888-551-3082!
We respect your privacy. Your information is safe and will never be shared.
Secure Online
Checkout
Free Ground
Shipping
One Year
Warranty
The EK1100-0008 EtherCAT coupler is built by Beckhoff for the EK EtherCAT Couplers series. Intended for cabinet installation, the device forms the interface between an EtherCAT fieldbus segment and the company's electronic terminal system. It receives telegrams from the controller, strips the EtherCAT frame, and forwards process data over the internal E-bus so that digital, analog, or motion terminals mounted to its right can operate in synchrony. By combining network conversion and power feed in one module, the coupler reduces panel wiring and preserves deterministic cycle times.
Two fieldbus ports with 2 x M8 connectors permit line or ring layouts without auxiliary switches. Communication uses Ethernet 100BASE-TX at a fixed transfer rate of 100 MBaud, providing deterministic update windows for time-critical machine cycles. Cable runs may reach 100 m between nodes when standard shielded Category 5 cable is used. The unit follows the EtherCAT Device Protocol and therefore requires no local configuration. A dedicated system supply of 24 VDC powers the electronics, while the integrated power contacts can pass up to 10 A downstream so feedback terminals and actuators receive energy through the same stack.
Inside the housing, the internal backplane operates at 5 V and may deliver up to 2 A along the E-bus, supporting sensors and logic modules without separate regulators. The architecture accommodates 65,535 EtherCAT terminals, enabling extensive I/O expansion on a single coupler. Mounting is accomplished on a 35 mm rail that complies with EN 60715, and the enclosure carries an IP20 ingress rating suitable for protected control cabinets. Continuous operation is allowed at relative humidity levels up to 95%, provided condensation is avoided. Because no parameter entry is required, the device automatically identifies itself to the master when the rail is energized.
Technical Specifications
Bus Interface
2 x M8
Configuration Required
No
Data Medium
Ethernet 100BASE-TX
Data Rate
100 MBaud
E-bus Voltage
5 V
Max Cable Length
100 m
Max E-bus Current
2 A
Max Ethercat Terminals
65535
Max Relative Humidity
95%
Mounting
EN 60715 35 mm Rail
Power Contact Current
10 A
Power Contact Voltage
24 VDC
Protection Rating
IP20
Protocol
EtherCAT Device Protocol
Supply Voltage
24 VDC
Contact Us
1620 Old Apex Road, Cary, NC 27513, USA
Toll Free: 1-888-551-3082
International: 1-919-443-0207
Fax: 1-919-867-6204
Email: sales@wakeindustrial.com
Need Assistance?
Our team is here to help you find the right part for your needs.







